FLUX Vertical Immersion Pumps

Description

F620 S - With Mechanical Seal :

-for transferring low flammabiltiy liquids from containers, either open topped or closed

-consisting of an inner tube and outer tube; the drive shaft is supported within the inner tube

-a mechanical seal in ceramic oxide, o-rings in FKM, separates the liquid from bearings and upper shaft

-with an open conical impeller

-2 sizes: 15 and 30 to meet varying capacity requirements

F640 PP - With Mechanical Seal :

-for transferring larger volumes of low flammabiltiy liquids from containers, either open topped or closed, tanks, reservoirs, etc.

-consisting of an inner tube and outer tube; the drive shaft is supported within the inner tube

-a mechanical seal in ceramic oxide/SiC, o-rings in FKM, separates the liquid from bearings and upper shaft

-a steel cored inner tube in PP provides the ultimate in stability, preventing elongation of the plastic at high temperatures

-with open conical impeller or closed centrifugal impeller (Z)

-4 sizes: 15, 15 Z, 30 and 30 Z to meet varying capacity requirements

F706 PP - With Slide Bearing :

-for transferring corrosive liquids in the chemical industry and chemical engineering together with any application that requires the safe and economical transfer or circulation of acids and alkalis or other chemical fluids, with or without solids in suspension

-with slide bearing, lubricated by the liquid, for immersion lengths up to 2000 mm

-very smooth running, due to a large PP-coated drive shaft and a thick-walled support tube

-very long service life and extended maintenance intervals, even in the case of continuous use

-range of carefully chosen impeller diameters

-4 sizes: 135, 185, 230 and 350 to meet varying capacity requirements

F716 PP and PVDF - Compact pump design :

-for transferring neutral or corrosive liquids in the chemical industry and chemical engineering, electroplating, steel or stainless steel pickling plants, flue gas decontamination, exhaust air purification, fresh and waste water treatment

-integral three-phase motor with extended, free flying shaft, allowing the pump to use the motor shaft

-no seals or bearings in contact with the liquid

-very smooth running, due to robust support tube or support bars solidly connected to the mounting flange

-very long service life and extended maintenance intervals, even in the case of continuous use; suitable for dry running

-range of carefully chosen impeller diameters

-with mounting flange for stationary installation

-4 sizes: 115, 135, 185 and 230 to meet varying capacity requirements

F726 PP and PVDF - For extreme operating conditions :

-for transferring neutral or corrosive liquids in the chemical industry and chemical engineering, electroplating, steel or stainless steel pickling plants, flue gas decontamination, exhaust air purification, fresh and waste water treatment

-version with support bars for extreme operating conditions

-free flying pump shaft without any seals or bearings in contact with the liquid

-very smooth running, even under heavy load, due to robust pump shaft supported in an upper pedestal

-very long service life and extended maintenance intervals, even in the case of continuous use; suitable for dry running

-range of carefully chosen impeller diameters

-with mounting flange for stationary installation

-4 sizes: 115, 135, 185 and 230 to meet varying capacity requirements